Samknows router setup

Bob Nielsen n7xy at clearwire.net
Sun Feb 13 10:07:24 PST 2011


I guess it just won't forward that port.  I put the Netgear router into bridge mode and hooked the Linksys ahead of it so the cluster node is working again.  Not the cleanest solution, but it works and still supplies the Samknows reporting.

Bob

On Feb 12, 2011, at 2:03 PM, Bob Nielsen wrote:

> I kept after it and port forwarding is partially working.  I misread the instructions and thought there should be an apply button on the main port forwarding screen.  It is working for torrents but for some reason it isn't forwarding port 7300 for DX spider.
> 
> I'll keep trying.
> 
> Bob
> 
> On Feb 12, 2011, at 12:21 PM, Gary P. Fiber wrote:
> 
>> I believe you need to add a HTTP service along with a IP address then click edit and change your port number. On my samknows router there is an apply in the Ports-Custom Services screen, that comes up when you edit the port number
>> 
>> Gary
>> 
>> On 2/12/2011 11:01 AM, Bob Nielsen wrote:
>>> Since several of you have the Samknows Netgear WNR3500L router, perhaps someone knows the answer to my question.
>>> 
>>> I am running a DX Spider (DX cluster) node on my Sheevaplug.  I need to forward incoming connections on port 7300 to this device.  On the router I can add the service and specify the port (under Port Forwarding/Port Triggering), but there is no "apply" button to actually enable the forwarding.
>>> 
>>> I sent an email to samknows, but would like to get it resoved ASAP.  Any ideas?
>>> 
>>> Bob, N7XY
>>> _______________________________________________
>>> Seatcp mailing list
>>> Seatcp at wetnet.net
>>> http://wetnet.net/mailman/listinfo/seatcp
>>> 
>> 
>> 
>> -- 
>> Gary Fiber K8IZ
>> GROL PG-19-6691 with shipboard radar endorsement
>> Washington State resident
>> 
>> _______________________________________________
>> Seatcp mailing list
>> Seatcp at wetnet.net
>> http://wetnet.net/mailman/listinfo/seatcp
> 



More information about the Seatcp mailing list